Publicité
Les langues disponibles
Les langues disponibles
Wooden doors
Mark the drilling points and then remove the drilling tem-
plate and the code lock from the door. Use wood drills of 10
mm dia. for the M 5 fixture screws and of 16 mm dia. for
the battery connection cable ( see page 25 for furthe r de-
tails ).
Sheet metal and metal doors
Mark the drilling points and then remove the drilling template
and the code lock from the door. Use metal drills of 6 mm dia.
( see page 26 for further details ).
Widen the fixture borings to 10 mm in diameter on the
outside of the door using a centre bit. The boring for the
battery connection cable has to be widened on the inside
and outside of the door to a diameter of 16 mm.
In the case of sheet metal doors the M 5 joining screws may
not be overtightened, otherwise the door may be deformed
in the area of the lock.
Finished assembly
Fitting of the code lock's outer furniture
Fitting of the code lock's inner furniture
Screw connection of the code lock furnitures:
Each packing unit includes 4 x 2 hardware screws. The
length of the fixture screws is determined by the door leaf
thickness and the code lock type ordered.
Code lock ordering off 495-10
door leaf thickness
Furniture top
Furniture bottom
Press-fit and screw connection of door handles
The code lock should be put into operation before the 4
plastic cover bushes supplied for the installation borings are
pressed on ( see initial operation and programming ).
Initial operation and programming
Prior to initial operation of the electronic code lock a 9 volt
battery block has to be inserted into the code lock. For this
purpose the battery compartment on the side of the inner
furniture of the code lock has to be opened using a
screwdriver, in order to plug in the battery via the connection
clip. The battery block is not supplied by us.
8
495-11
38-50 mm
50-70 mm
2 pcs. each
2 pcs. each
M 5 x 55
M 5x 80
2pcs. each
2 pcs. each
M 5x 45
M 5 x 65
Publicité
