Remote Control; Cleaning And Maintenance - Jumbo ayce DF-HT3810P Manuel D'utilisation

Memory function in standby mode:
●
When pressing the key to turn on the appliance under the standby mode, the
appliance will memorize the previous using setting (except timer setting) and work
accordingly.
The brightness of the display section will be reduced to 1/3 of the normal bright-
●
ness after 1 minute of working in order to avoid the LED lamp dazzling at night, and
it will restore the brightness after any operation.
NTC over-heating protection function:
●
When the NTC ambient temperature rises over 55°C, the machine will be forced to
turn off (all LED lights will turn off, timing stops, as well as the swing &PTC heating
element, and the fan will be off after 10 seconds).The machine can only be restarted
to work again by manual operation when the NTC ambient temperature is less than
45°C, and the appliance will have no memory function. The appliance will be turned
off automatically after contiunously working for 12 hours even if the timer is not set.

REMOTE CONTROL

Power button
Timer +(up) button
Timer – (down) button
High/Low
heating power button
Swing button
Temp+(up)button
Temp-(down) button
High / low fan power button
HOW TO INSTALL BATTERIES
1. Pull out the battery door at the back side of remote control (see Picture1).
2. Pay attention to the battery polarity, and insert the battery（CR2032 3V）into the tray of
the door (see Picture 2).
3. Push the battery door into the remote control.
Remote control Battery door
Picture 1
Picture 2
NOTICE
1. If you don't use the product for a long time, take out the battery.
2. To prevent environmental pollution, take out the used battery and dispose safely and
appropriately.
HOW TO USE
To operate the heater, aim the remote control at the signal receptor. The remote control
works at a distance up to 6m when pointing at the heater.

CLEANING AND MAINTENANCE

1. Make sure the heater has been unplugged from the power and completely cooled down
before cleaning.
2. Do not use gasoline, thinner, diluents and other liquids which will damage the
heater surface.
3. Wipe with a dry cloth to remove dust and a damp cloth (not wet) to clean off stains, be
careful not to allow moisture into the heater.
56 | 57
GB