Bosch TCC78K751 Mode D'emploi page 51

– Calc'n'Clean : If you want to descale
and clean the appliance at the same
o
time, press start/stop (10) and run
the Calc'n'Clean programme (see
"Calc'n'Clean").
– Water hardness
p
. Turn the knob
quired water hardness (1, 2, 3 or 4) (refer
also to "Checking and setting the water
hardness").
– Coffee temperature
p
button . Turn the knob
temperature.
– : Press the arrow button
Auto off after
Turn the rotary knob
span after which the appliance should
automatically switch off following the
last drink preparation. A time between
5 minutes and 8 hours can be set. The
default time is 30 minutes, but this can
be shortened to save energy.
– Illumination : Press the arrow button
The lighting can be set to
setting) or
Off after 5 min
– Tone : Press the arrow button
audible signal you hear when a button is
pressed can be switched
turning the rotary knob
– : Press the arrow button
Contrast
display contrast can be set from –20 to
+20 with the rotary knob
setting is 0.
– Water filter : Each time a new water filter is
inserted in the water tank (14), it must be
rinsed:
1. Place the water filter in the water tank
(14) and fill the tank with water up to
the "max" mark.
Start with O
2. Press the arrow button
[
o
and press
3. Place a container with a capacity of 0.5
litres under the milk frother (12).
Bosch
: Press the arrow button
to select the re-
: Press the arrow
to set the coffee
to enter the time
Off , On (factory
.
p
. The
OFF or ON
.
p
. The default
p
]
start/stop (10).
4. Press
run first through the filter to rinse it and
then into the container.
Empty the container. The appliance is
ready to use once more.
Rinsing the filter simultaneously activates
the setting for the
display.
The filter is no longer effective when the
Service - change filter
or at the latest after two months. It needs
to be replaced for reasons of hygiene and
so that there is no build-up of limescale
p
. (this could damage the appliance).
Replacement filters can be obtained
from retailers or customer service (see
"Accessories").
After every filter change the filter must first
be rinsed. Proceed as described at the
beginning of this section.
If no new filter is used, turn the water filter
p
. setting to
by
. The
– factory settings
settings and reset the factory settings. To
activate the factory settings, press
stop (10).
o
start/stop (10). Water will now
Service - change filter
display appears,
Off .
You can find detailed information
about the water filter in the en-
closed filter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should be
rinsed before the appliance is used
again. To do this, simply dispense a
cup of hot water.
: You can cancel your own
TCC78K751 | 02/2014
English | 49
o
start/