In The Event Of Problems; Disposal; Technical Specifications; Warranty / Service - Beurer MG 315 Mode D'emploi

• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• The removable cover is machine-washable at 40ºC. Please note the symbols for care and cleaning
on the label sewn into the cover.
The back mesh cover is attached with a zip above the neck area.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
Alternatively, you can hang the device in a wardrobe with a coat hanger. To do so, the coat hanger must be
threaded through the hanging loops on the rear side of the device.
Ensure that you use a stable clothes hanger made from wood that is able to carry the weight of the device.

9. In the event of problems

Problem
Massage heads
are moving slowly.
Massage heads are
moving in the upper
or lower area only.
Massage heads
not moving.

10. Disposal

CAUTION
For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.

11. Technical specifications

Disposal:
Dimensions:
Weight:

12. Warranty / service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides
a warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
Cause
The load on the massage
heads is too great.
The massage has been acti-
vated for the limited region.
Appliance not connected to
the power supply.
Device not switched on.
Overheating protection
tripped, device is damaged.
100-240 V~, 50/60 Hz, 36 W
48 x 14 x 87 cm
approx. 5.8 kg
Remedy
Reduce the contact pressure on the head.
Press the full, back or neck button to change or
extend the area.
Connect the plug to the mains supply and switch on
the appliance.
Switch the device on with
Select the massage region.
Contact your authorized dealer or the service ad-
dress.
17
.