Commissioning - Trotec DA 4 Mode D'emploi

Repair and maintenance work on electrical parts may
only be executed by a specialist electrician. On cons-
truction sites, the DA 4 may only be connected via an
electrical 1~230 V, 50 Hz; 16 A energy supply with a
corresponding upstream FI residual current operated
protective device (RCD) 30 mA, in accordance with
with DIN VDE 100.
In order to avoid faults, the device is to be cleaned at
regular intervals during or after each use, depending on
individual loads.
When using extension cables or cable drums, the
cable must always be rolled off completely.

03. COMMISSIONING

• Ensure that the inlets and outlets are free. Remove
any plugs or foreign bodies from the nozzles and lines.
• Install the required elements for the insulation layer
vacuum drying (water extractor, filter, compressor
and exhaust mufflers).
• Connect the hoses coming from the core drilling
holes to one side of the DA 4.
• Connect the hoses coming from the DA 4 with the
water extractor for the insulation layer drying.
• Plug the black humidity sensor by means of the
screw-in adapter into an inlet of the 4-fold distributor
at the compressor (figure 2). Or use the Quad Distri-
butor Pro VE/VX (6.100.000.142) with the additional
sensor socket.
(Fig. 2: arrangement of the MultiQube elements)
B - 3
A - 3
• Place the grey room air sensor near the condensa-
• Connect the device to the power supply.
• The device is now ready for operation.
• Carry out a reset: Hold down the key (10). After 4
m You have to RESET with each new use.
• Follow the instructions on the display and press
If a different text is visible on the display, press the
key for 6 seconds in order to reset the programme.
The device will start.
m The DA 4 may only be commissioned and
230 V
Operating manual – DA 4 / DA 4 M Discharge Control Unit
tion dryer.
seconds, a countdown appears on the display. Once
the countdown has finnished, please release the key.
the reset push-button when prompted.
operated by professional users.
EN
DE