EGO LM2135E-SP Notice D'emploi page 13

TROUBLESHOOTING
WARNING:
Always remove the safety key and battery pack when servicing or transporting the mower. Always
protect your hands by wearing heavy gloves or wrapping the cutting edges with rags or other materials when
performing any maintenance on the mower blade.
CAUSE
PROBLEM
◾
The battery pack is depleted.
◾
The battery pack is not mounted in place in
the battery compartment.
◾
The battery or mower circuitry is too hot.
(The power indicator on the mower will
illuminate in orange for 10 seconds)
The mower fails ◾
The side rails are not extended to their
to start
maximum length and the clamps are not
locked in position.
◾
The handle is not set at one of the three
operating positions.
◾
The mower deck is clogged with grass and
debris.
◾
The blade is dull.
◾
The cutting height is not set properly.
The mower cuts
unevenly
◾
The blade is assembled incorrectly.
◾
The battery pack is depleted.
◾
Mower is in overload condition.
◾
Mower deck is clogged with grass and
The mower stops debris.
while mowing
◾
The battery or mower circuitry is too hot. (The
power indicator on the mower will illuminate
orange for 10 seconds.)
◾
The side rail is retracted a little by the
pushing force applying on the handle.
◾
Wet grass clippings are sticking to the
underside of the deck.
The mower does
not mulch properly
◾
The mower is set to cut too much grass at
once.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2130E-SP
SOLUTION
◾
Charge the battery pack.
◾
Attach the battery pack to the mower;
press it until you hear a click
◾
Allow the battery pack or mower to cool
until the temperature drops below 67°C.
◾
Fully extend the handle and lock both
clamps.
◾
Adjust the handle to one of the three
operating positions.
◾
Clean the mower deck and make
certain that the blade has freedom of
movement.
◾
Sharpen or replace the blade.
◾
Raise the deck to a higher cutting height
setting.
◾
Reassemble the blade, following the
section "INSTALLING THE BLADE" in this
manual.
◾
Charge the battery pack.
◾
Raise the cutting height or slow down the
mowing.
◾
Unclog the mower deck. Raise the
cutting height, or cut a narrow swath.
◾
Allow the battery pack or mower to cool
until the temperature drops below 67°C.
◾
Unlock the clamps. Fully extend the side
rails and lock the clamps again.
◾
Wait until the grass dries before mowing.
◾
Raise the deck to a higher cutting height
setting.
EN
11