General Maintenance - EGO LM2135E-SP Notice D'emploi

To operate the self-propel system without blade rotation,
turn the self-propel speed-control knob on, press the
self-propel trigger(s).There are two self-propel triggers.
Press either trigger to start the self-propel function (Fig. O).
O-1 Self-Propel Speed-Con-
trol Knob
To turn the self-propel off, release the self-propel trigger,
turn the self-propel speed-control knob off.
MOWER-STATUS INDICATOR ON THE MOWER
(Fig. P)
The mower is equipped with a power indicator to indicate
the charge status of the battery pack and the working status
of the mower. The power indicator will illuminate when the
blade is rotating or when the LED headlights are turned on.
P-1 Mower-Status P-2
Indicator
Mower-
status Meaning
indicator
Mower is work-
ing properly;
Solid green battery has at
least 15% of its
charge.
The side rails
are not fully
extended.
Flashing green
The handle is
not locked in
an operating
position.
Flashing red Low battery.
The mower
Solid orange stops due to
overheat.
Flashing The mower is
orange overloaded.
Flashing red/
green alter-
nately
O-2 Self-Propel Trigger
Dark & LED
on battery
flashing
MOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too
much grass at one time. Slow down your cutting pace or
raise the cut height.
Your mower has built-in overload circuit protection. When
Switch Button for
the mower is overloaded, the motor will stop and the
LED Headlights
mower-status indicator on the mower will flash orange.
Remove the battery pack from the mower. Check to see
if grass has collected beneath the deck and clear it if
necessary, then install the battery and restart the mower.
Action
BATTERY HIGH TEMPERATURE PROTECTION
The battery pack will generate heat during operation. The
heat dissipates more slowly in hot weather. If the battery
None required.
temperature exceeds 70°C during operation, the protection
circuit will immediately turn off the mower to protect the
battery pack from heat damage. The mower-status indicator
on the mower will off, please see 'BATTERY PROTECTION'
Stop the mower and
section in battery operator's manual. for details.
make sure that the side
Release the bail switch, wait until the battery pack cools
rails are fully extended.
down to approximately 67°C, then restart the mower.
Stop the mower and
MAINTENANCE
make sure that the
handle is locked in an
operating position.
remove the safety key from the mower before cleaning,
Stop the mower and
performing any maintenance or transporting the mower.
charge the battery pack.
Remove the battery
replacement parts. Use of any other parts may create a
from the mower, move
hazard or cause product damage. To ensure safety and
them to the shade and
reliability, all repairs and replacements should be performed
cool them at least 15
by a qualified service technician.
minutes.
First remove the battery

GENERAL MAINTENANCE

pack, then check and
clean if grass has collect-
pack when servicing or transporting the mower.
ed beneath the deck. Slow
down your pace when
The underside of mower deck should be cleaned after each
use, as grass clippings, leaves, dirt and other debris will
cutting. If this does not
accumulate.
work, please contact EGO
customer service center.
Remove any build-up of grass on or around the motor fan
(do not use water). Wipe the mower clean with a damp cloth.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2130E-SP
Contact EGO customer
Error
service center.
Battery over-
heat. (See sec- Release the bail switch,
tion "BATTERY
wait until the battery
HIGH-TEM-
pack cools down to ap-
PERATURE
proximately 67°C, then
PROTECTION" restart the mower.
in this manual)
WARNING:
To avoid serious personal injury, always
WARNING:
When servicing, use only identical
WARNING:
Always remove the safety key and battery
EN
9