Mitsubishi Electric Mr.SLIM PKA-RP HAL Série Manuel D'utilisation page 8

Masquer les pouces Voir aussi pour Mr.SLIM PKA-RP HAL Série:
Table des Matières

Publicité

5. Operation
• Each press changes the direction. The current direction is shown at .
• The change sequence and the available settings are as follows.
Remote controller
Swing
Auto
Wired type
Swing
Wireless type
* Note that during swing operation, the directional indication on the
screen does not change in sync with the directional vanes on the unit.
Note:
Press the louver button
as necessary.
• The louver image
appears.
Each press of the button switches the setting as follows.
(ON)
(OFF)
Wired remote
controller
No display
During swing operation, the arrow display
(Stop)
move to the left and right.
Wireless remote
controller
No display
During swing operation, the arrow display
(Stop)
move to the left and right.
* The louver button
cannot be used.
• Stop the unit operation, hold the lever of the louver,
and adjust to the desired direction.
* Do not set to the inside direction when the unit is
in the cooling or drying mode because there is a
risk of condensation and water dripping.
Caution:
You can use Function Selection of remote controller to select which of
3 types of timer to use:
Weekly timer,
timer.
The weekly timer can be used to set up to 8 operations for each day
of the week.
• Each operation may consist of any of the following: ON/OFF time
together with a temperature setting, or ON/OFF time only, or tem-
perature setting only.
• When the current time reaches a time set at this timer, the air condi-
tioner carries out the action set by the timer.
Time setting resolution for this timer is 1 minute.
Note:
in effect.
8
as necessary.
Display
1
2
3
4
5
1
2
3
4
(Only for PS type)
Simple timer, or
Auto Off
To run the ventilator together with the indoor unit:
Press the ON/OFF button
• The Vent indication appears on the screen (at
will now automatically operate whenever the indoor unit is running.
To run the ventilator only when the indoor unit is off:
Press the Mode button
until
will cause the ventilator to start.
To change the ventilator force:
Press the Ventilation button
• Each press toggles the setting as shown below.
(Low)
(High)
Note:
Operation No.
Day Setting
SUN
C
TEMP.
MENU
ON/OFF
BACK
MONITOR/SET
DAY
OPERATION
PAR-21MAA
CLOCK
1. Be sure that you are at a standard control screen, and that the weekly
timer indicator
is shown in the display.
.
). The ventilator
appears on the display. This
as necessary.
ON
WEEKLY
ON/OFF
FILTER
CHECK
TEST
CLEAR

Publicité

Table des Matières
loading

Table des Matières