Use - Cartrend 80320 Mode D'emploi

use

Information about use
Warning!
• Do not aim the water jet at the eyes or other persons. the water jet is pressurised and
can cause serious injuries.
• ensure that there are no people or animals in the work area.
caution!
• If the unit is not being used for more than 5 minutes, switch the unit off (set switch to
OFF position).
• verify the hose is connected correctly and the spray gun and its attachment are securely
seated.
• some car outlets will only become active once the ignition is turned on. Please refer to
your vehicle's operating manual or contact your specialized garage if you are unsure.
• Do not cover the device during use and ensure proper ventilation.
• Keep your workplace clean and tidy. untidiness and poorly-lit working areas can lead to
accidents.
Preparation
1. Open the cover (1):
unscrew the cover counter-clockwise.
attention!
• Only fill the water reservoir with pure, clean water as the water line may otherwise clog
and the unit be damaged.
• Do not add detergents.
2. Fill the water reservoir (7) with fresh water (max. 15l).
Water temperature: approx. 10°c to 50°c
3. close the cover (1):
tighten the cover clockwise.
connecting the hose
connect the hose (13) to the hose connector
(5).
1. slightly pull back on the connector to do
so
2. Place the hose coupling (12) over the hose
connector (5) on the unit.
3. Release the hose coupling. Be sure the
hose coupling locks into place.
20
Mobile Cleaning Station