Cleaning And Maintenance; Cleaning The Filter - Beurer LR 310 Mode D'emploi

1. Press the ON/OFF button to switch off the air
purifier, and unplug it from the socket.
3. Pull out the pre-filter. Now, to pull out the combi
filter, pull carefully on the side tabs.
5. Re-insert the housing cover as shown until
you see and hear it click into place (magnetic
fastening). First attach the magnetic fastening
at the top, and then at the bottom.
If you wish to change the combi filter at specific personal intervals (e.g. every six months), there is a
sticker on the upper edge of the combi filter on which a date can be entered.

8. Cleaning and maintenance

WARNING
Before cleaning, always ensure that the mains plug of the air purifier has been properly disconnected.

8.1 Cleaning the filter

Regular cleaning of the filter (once a month) is a prerequisite for hygienic and fault-free operation.
• Clean the three-layered filter using the brush attachment of a vacuum cleaner. To carry out a thorough clean,
pull out the pre-filter and clean the activated carbon filter located behind it and the HEPA filter located at the
rear, also using the brush attachment from a vacuum cleaner. Then replace the pre-filter on the HEPA filter.
1.
2.
2. Remove the housing cover as shown (magnetic
fastening). Firstly detach the magnetic fastening
at the bottom, and then at the top.
4. Insert a new combi filter. To insert the combi filter
correctly, align it with the side tabs as shown. Po-
sition the pre-filter above it.
6. Insert the mains plug into the socket. Ensure that
the cable does not pose a trip hazard. Press and
hold the AUTO button (
operating hours counter now resets to 0.
19
2.
1.
) for five seconds. The