Installation Of Batteries - BST UDR208 Manuel D'utilisation

1) Power button: Used to switch the receiver on or off.
2) Volume control: Used to adjust the volume of the output of the each channel of the receiver
3) Down button: Used to adjust the number of the wireless channel ( from 1 to 8 ) for each channel
4) Display: Shows the channel number ( from 1 to 8 ), the corresponding frequency and RF level
5) Up button: This button is used to select the wireless channel ( from 1 to 8 ) for each channel
6) AF led: These leds gives you visual information about sound level for each channel. If the led lights in red,
that means the signal is too strong. You must to decrease the volume.
7) Charger: If you want to charge the handheld microphone, place it on this hole. During the charge, the
«charger» led flashes.
8) Antennas: Keep the position of antenna at a 45 angle from vertical.(See below)
9) Aux unbalanced output: This output is the mixed output. The output signal is the mix of the two channel
signals. Connect it to a mic input of a mixer.
10) Channel balanced output: These outputs are channel outputs. Connect it to mic inputs of a mixer
11) Power supply socket: Connect on this socket to the power supply adapter (13-15V��/1000mA).
DESCRIPTION HANDHELD TRANSMITTER
1) Cartridge
2) Display: Shows the channel number and corresponding frequency
3) Down button: Used to select the wireless channel ( from 1 to 8 )
4) Up button: Used to select the wireless channel ( from 1 to 8 )
5) ON/Mute/Off button
• Put to ON to switch the transmitter on and to enable the wireless link
• Put to MUTE to switch the transmitter on but disable the wireless link
• Put to OFF to switch the transmitter off
4) Battery compartment cover

INSTALLATION OF BATTERIES

To change the batteries of handheld mic :
- Unscrew the battery cover
- Pull out the low batteries.
- Insert the new batteries ( Be careful to the polarity of the batteries )
- Screw the batteries cover.
Note : If you want to user built-in charger, you must to use rechargeable batteries
(not normal alkaline batteries )
IMPORTANT: Only charge 1 mic at a time otherwise the charging current would
be too high and the charger would shut down.
UDR208 • 3