Taurus MEGANE 2000 ADVANCE Mode D'emploi page 17

- Multi-use brush
Use:
- Take the length of cable required
out of the housing.
- Connect the appliance to the
mains.
- Turn the appliance on using the
on/off switch.
Electronic power control:
- The power of the appliance can
be regulated by using the power
regulator control. This function is
very useful, as it makes it possible
to adapt the power of the appliance
to the type of work that needs to
be done.
Once you hace finished using the
appliance:
- Turn the appliance off, using the
on/off switch.
- Unplug the appliance to the
mains.
- Retract the cable by pressing the
roller cable button and guide the
cable into the appliance.
Carry handle/s:
- The device has a handle on the
upper part so it can be transported
easily and comfortably.
Parking position:
- This appliance has two parking
positions for comfortable and
straightforward storage.
- To make use of the vertical
parking put the appliance in a
vertical position (so that the back
part of the appliance is now leaning
against the floor) secure the hook
of the head to the hook which can
be found on the lower part of the
appliance (Fig. 2).
- To use the horizontal parking
position, fix the break pad hook
to the hook situated on the rear
side of the appliance (Fig. 3).
Safety thermal protector:
- The appliance has a safety device,
which protects the appliance from
overheating.
- If the appliance turns itself
off and does not switch itself on
again, disconnect it from the mains
supply, and wait for approximately
15 minutes before reconnecting.
If the machine does not start
again seek authorised technical
assistance.
Cleaning
- Disconnect the appliance from
the mains and let it cool before
undertaking any cleaning task.
- Clean the equipment with a damp
cloth with a few drops of washing-
up liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
Emptying the vacuum content
deposit:
- Empty the vacuum deposit
when dust is visible though the
transparent walls, when it is full, or
when the vacuum cleaner does not