Cleaning And Care; Metal Filter - GUTMANN EM 04 Mode D'emploi

Cleaning and care

Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse. Dur-
ing cleaning, make sure that no water
penetrates the device. Timely cleaning
of the surface saves the later laborious
removal of stubborn contamination. Only
use conventional detergents or universal
cleaning agents for cleaning suitable for
stainless steel/aluminium. Never use
abrasive cleaning agents or steel wool.
After cleaning the hood, treat the
stainless steel surfaces with a stainless
steel care product.
Painted surfaces and the control panel
should only be cleaned using a mild
detergent solution and a very soft cloth.
Do not use stainless steel cleaners for
the sliding switch/pressure switch.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Note: Do not use alcohol (spirits)
on plastic surfaces, as dull spots may
result.
Caution: Ensure the kitchen is properly
ventilated. Avoid naked flames.

Metal filter

Removing the filter
Fire hazard! Grease residues decrease
the extractor's performance and in-
crease the fire hazard. The metal filter
must be cleaned regularly (at least
every 14 days) to prevent a fire hazard.
The necessary cleaning of the grease
filter is also shown via the LED indicator:
the red LED on the ceiling unit lights up
as of 15 operating hours. Please clean
the metal filter as soon as possible. Pull
the stainless steel front down gently until
the magnetic contact releases. Pivot the
stainless steel front slowly. The metal
filter behind it can now be removed. The
metal filter is best cleaned in the dish-
washer with a mild dishwashing agent.
The manufacturer accepts no liability
whatsoever for any discolouration
caused by the use of aggressive clean-
ing agents. Temperatures exceeding 55
degrees must also be avoided.
Caution: Do not use three-phase clean-
ing agents or multiphase cleaning
agents. Do NOT clean the metal filter in
an industrial washing machine. Cleaning
with aggressive agents such as petrol,
acetone, trichloroethylene, etc., will de-
stroy the filters!
After cleaning, replace the metal filter
and then keep the toggle switch (F= filter
saturation) pressed to the right for 10
seconds. This resets the operating
hours counter and the RED light goes
out. Then lift the stainless steel front up
again until it closes.
en
17