Installation; Operation; Setting The Temperature; Interior Light - Polar Refrigeration G834 Mode D'emploi

Telephone Helpline: 0845 146 2887 (United Kingdom)

Installation

Note: If the unit has not been stored or moved in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging and the protective film from all surfaces.
1.
Avoid positioning the appliance in direct sunlight or damp areas.
2.
When positioning the appliance, maintain a distance of 20cm (7 inches) between the appliance and
3.
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
4.
of the appliance.
If necessary, adjust the screw feet of the appliance to make it level.
5.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.

Operation

Setting the Temperature

The temperature dial is located at the back of the
interior cabinet [Fig.1].
Turn the temperature dial clockwise to set
1.
the desired temperature.
0 - OFF
1 - 9°C
2 - 8°C
3 - 7°C

Interior Light

The cabinet has an interior light that can be
turned On/Off as required.
The switch is located on the roof of the interior cabinet.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
4 - 6°C
5 - 4°C
6 - 3°C
7 - 2°C
Fig. 1
UK
2