Maintenance; Maintenance Schedule; Daily Maintenance - Jonsered CS 2234 Manuel D'utilisation

• If the log is supported on one end, cut 1/3 the
diameter from the underside of the log (known as
underbucking) .
• If the log is supported on both ends, cut 1/3 the
diameter from the top. Complete the cut by
underbucking the lower 2/3 of the log to meet the
first cut.
WARNING: Read and understand the
safety chapter before you clean, repair
or do maintenance on the product.

Maintenance schedule

Make sure that you obey the maintenance schedule.
The intervals are calculated from daily use of the
product. The intervals are different if you do not use
the product each day. Only do the maintenance work
that is found in this manual. Speak to an approved
service center about other maintenance work not
found in this manual.

Daily maintenance

• Clean the external surfaces.
• Make sure that the lockout and trigger work
correctly.
• Clean the chain brake and make sure that it
works correctly.
16
• If you buck a log on a slope, always stand on the
uphill side of the log. Cut through the log while
you maintain complete control of the product,
then release the cutting pressure near the end of
the cut while firmly gripping the rear handle and
front handle.

Maintenance

• Examine the chain catcher for damage. Replace
the chain catcher if it is damaged.
298 - 004 - 14.10.2019