GE WNRD2050 Manuel D'utilisation page 12

Before you call for service...
Troubleshooting Tips
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
Movement inside
machine when shut off
No rinse fill
12
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
Shifting mechanism is
disengaging the motor
This is normal
What To Do
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.
• When the machine is manually turned off, the shifter
will disengage the motor before completely shutting
down. If the lid is raised before the motor is disengaged,
it will resume when lid is closed.
• This machine uses three low-water spray rinses to remove
soap from clothes and reduce water consumption.