Electrical Connections - Balluff BFF T-003-A2A-S4 Série Notice D'utilisation

Inline flow controller with LEDs
BFF T_ _ _ _-_ _003-_ _ _A2A-S4
Safety notes
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allows him to assess the work
assigned to him, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the measuring system
will not result in hazards to persons or equipment.
If defects and unresolvable faults occur in the flow
controller, take it out of service and secure against
unauthorized use.
General safety notes
Turn off power to the system before connecting the flow
controller.
Before installing the flow controller turn off power to the
system, block off the pipeline and watch for escaping
medium.
Self-heating of the flow controller can mean that the device
surface has a higher surface temperature than the
monitored medium. Take precautionary measures before
working on the device.
Always observe the safety instructions in this guide and the
measures described to avoid hazards.
Explanation of the warnings
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
► Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a danger that could damage or destroy the
product.
2 english
Display and operating elements
Yellow LED, output
Red LED
Potentiometer
Fig. 2: Display and operating elements
Element
Green LED On when the set limit value is
exceeded.
Yellow LED On when the set limit value is reached.
Red LED On when the set limit value is
undershot.
Potentiometer Setting the limit:
– Turning clockwise results in a lower
limit value.
– Turning counter-clockwise results in a
higher limit value.

Electrical connections

Fig. 3: Pin configuration for round connector M12×1, 4-pin
Pin Sensor with switching output
1 Supply +
2
3 Supply –
4 Switching output 1 (S1)
Fig. 4: Wiring diagram
Green LED 1
Green LED 4
Green LED 3
Green LED 2
M12×1- connector
Function
n. c.