Adding Salt - Pelgrim GVW431RVS Mode D'emploi

FIRST USE

Adding salt

This machine is equipped with a water softener. To use the water softener, fill the
dishwasher with salt.
1
Ope n
1. Remove the bottom basket and then unscrew the cap from the reservoir.
2. Before filling the reservoir for the first time, pour in one litre of water.
3. Insert the funnel into the reservoir opening. Pour in approximately 1 kg of salt. It is normal
for a little water to flow out of the opening when doing this.
Note! Clear up any spilled salt and always run a full cycle immediately afterwards to
prevent damage to the bottom.
4. Screw the cap back on firmly.
Note! Always fill the salt reservoir and adjust the water hardness setting before using
the dishwasher. Refill the salt reservoir when the water softener indicator lights up. It is
possible that the light will remain lit for a short while after the salt reservoir is filled. It will
go out automatically when enough salt has been dissolved in the water.
2
EN 7