Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
In the left screen all operational cameras appear that are valid for one of the protocols.
5.
Select the desired IP cameras by checking them off in the left screen. (Max. 4) or
per camera: select the camera line (colour turns white) and then press the arrows
pointing to the right in the centre.
6.
In the right screen, select "Channel 1" for the first camera.
7.
Optionally, enter the user name of IP camera 1 ("admin" by default). The recorder
now attempts to establish a connection with the IP cameras. If the connection
fails, also enter the password for the concerned camera. Attention: it may take a
while for the image to appear (For Alecto cameras selected with ONVIF protocol
no "user name" required, Alecto cameras selected with I12H protocol requires
"user name" with "password" (default admin, Admin).
8.
In the upper right corner of the screen, select the concerned IP camera (channel
1 to 4).
9.
In this case, go to "Stream Type". Try to locate the correct stream until the image
appears. Choose from: Main stream, Main Stream + Sub Stream or Sub Stream.
Choose the streaming that shows the image.
10.
Press "Save" after each choice to determine whether the image appears.
11.
Press the "Exit" button to leave the pop-up screen.
By double-clicking the camera line in the right screen the concerned camera is selected
directly and you may change or remove any settings in the actual list (press centre arrows
pointing to the left).
While searching it may happen that an IP address still changes. In this case, the selected
camera won't function. Press "Search" again in the left screen to check whether the con-
cerned IP address is still correct.
-95-
Publicité
Table des Matières
