Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Network:
Network settings: To set the network settings of the NVR. Make sure that the router
to which the NVR is connected is set to DHCP.
NIC: Network Interface Card (only 1 interface card present)
IP: IP address for the network (advice: obtain the IP address by checking "Via
DHCP").
Subnet mask: Enter the subnet mask (not functional when using DHCP).
Default gateway: Enter the default gateway (not functional when using DHCP).
DNS server address1: Optionally, enter the DNS server address.
DNS server address2: Optionally, enter the DNS server address.
MAC address: MAC address of the NVR.
Default route: Select NIC1
Device port:
HTTP port:
RTMP port:
Enable RTSP: A check-mark means RTSP (Real Time Streaming Protocol) is
NTP settings: A setting for synchronizing the built-in clock with a NTP (Network
Time Protocol) server.
Management platform: Access authorization to the NVR.
Port 5050 is selected by default. This may be changed into any
desired port number.
Default internet port 80.
Port for using RTMP (Real Time Messaging Protocol), especial-
ly for streaming connections.
activated. Additionally, several RTSP settings are available.
-106-
Publicité
Table des Matières
