Customer Service - Siemens DO05705M Notice De Montage Et D'utilisation

A fault, what to do?
If your appliance does not operate as required, it is often due to a very minor problem. Please check whether you can remedy
the fault yourself by using the following guidelines. You will save yourself the costs of an unnecessary visit by customer service
personnel.
The electrical mains supply and the water supply must be shut off before all work on the appliance.
Fault
The appliance does not start
(heat), only cold water flows.
Water flow-rate is too low.
The tap drips during heat up
regardless of the drip stop.
The pressure stop has tripped,
water no longer flows.
If the fault could not be eliminated, please call customer service.

Customer Service

We ask you to always provide the E-No. and the FD-No. of
your appliance when calling in a customer service engineer.
You will find the number near both water connection nozzles
of the small water heater.
Disposal
This appliance is labelled in accordance with Euro-
pean Directive 2012/19/EU concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as appli-
cable throughout the EU.
Please ask your specialist retailer about current
disposal facilities.
en
Cause
The fuse in the house electrical
installation has tripped/blown.
The mains plug is not inserted.
The safety temperature limitation
has tripped.
The filter in the tap is clogged.
The filter in the cold water regulat-
ing valve is clogged.
The water outlet or the tap is
clogged by limescale.
Frequent, momentary dispensing
or dispensing with a low water
flow.
The drip stop function is defective.
The appliance has been incorrectly
installed on the water connection.
The fitting is clogged by limescale.
The warm water connection nozzle
is clogged.
Guarantee
The guarantee conditions for this appliance are as defined
by our representative in the country in which it is sold. De-
tails regarding these conditions can be obtained from the
dealer, from whom the appliance was purchased, or directly
from our representative in the country. Furthermore, the
guarantee conditions can also be found on the Internet at
the website address stated. The bill of sale or receipt must be
produced when making any claims under the terms of this
guarantee.
Solution
Check the fuse in the house electri-
cal installation.
Insert the plug into the mains
socket.
Unplug the mains plug, open the
warm water tap and allow approx.
4 litres of water to flow. Insert the
plug into the mains socket.
Remove the filter and either clean it
or descale it.
Remove, clean and reinstall the
inlet filter. Circulate water through
the appliance.
If necessary, repeat this procedure
until the filter is free of particles.
Descale or install a new fitting.
Longer dispensing, increase the
flow of warm water.
Exchange the appliance.
Connect the appliance correctly,
push in the red pin of the pressure
stop.
Descale the tap, push in the red pin
of the pressure stop.
Clean the warm water connection
nozzle and exchange the water con-
nection if necessary. Then push in
the red pin of the pressure stop.
Subject to change without notice.
Who
Customer
Customer
Customer
Customer
Servicing
expert
Servicing
expert
Customer
Servicing
expert
Servicing
expert
Customer
Servicing
expert
15