Italkero lightfire dolce vita 12 kW Instructions D'installation Et D'utilisation page 24

IMPORTANT! WHEN FIRST STARTED – IN THE OPEN AIR OR WELL-VENTILATED ENVIRON-
MENT – THE APPLIANCE COULD GIVE OFF VAPOURS OR SMELLS FOR A SHORT TIME.
IMPORTANT! PLEASE AVOID USING THE OUTDOORS, ESPECIALLY IN ADVERSE WEATHER
CONDITIONS.
The technical characteristics of the glass tube are particular and such as to enable the resi-
stance to thermal shock due to normal changes in temperature, humidity or light rain.
Despite the choice of this material (borosilicate), they can cause sudden failure of the pipe due
to particular weather events and / or temperature changes at low concentration.
IMPORTANT! Do not block the openings provided for ventilation of the cylinder holder and the
burner assembly.
IMPORTANT! CLOSE VALVE MAIL ON THE BOTTLE AFTER USE.
Ignition – MANUAL mod.
Regulation sequence, turn knob: OFF, spark ON, MIN and MAX;
1 – Make sure the ignition/regulation knob (Fig. 3: 8) is in OFF position (Fig. 5: 1) and open the
gas supply tap.
2 – Push and turn the ignition/regulation knob (Fig. 5) anticlockwise. The spark discharge and
gas opening for pilot ignition will start automatically.
Once the flame has ignited, continue to press the knob for about 15 seconds to allow the ther-
mocouple to heat up and keep the valve open. At this point, simply regulate the burner power:
Ignition – REMOTE CONTROL mod.
WARNING! Some infrared remote controls, if pointed directly to the appliance may interfere
with its operation.
Regulation sequence, by pressing the button on the remote control or directly on the control
unit: ON, MAX, MEDIUM, MIN, Burner OFF and OFF.
1 – Keep the ON/OFF button on the control unit (Fig. 6) pressed for about 2" until ignition
occurs. Once ignited, every time the ON/OFF button is pressed the appliance switches from
MAX to MEDIUM to MIN flame, Burner OFF and finally OFF.
IMPORTANT! This ignition delay is not a "fault" in the electronic control unit but has been purpo-
sely designed by the Manufacturer to ensure appliance safety and prevent accidental ignition.
IMPORTANT! If the pilot flame goes out, accidentally or due to lack of gas, the gas supply will
be automatically interrupted by means of the installed safety device.
IMPORTANT! Avoid repeated ignition attempts: if the appliance does not operate imme-
diately, make sure ALL the installation operations have been performed correctly.
IMPORTANT! During operation and also after switch off, DO NOT TOUCH the protection gril-
les, the burner unit, the glass pipe and the cover dish. These are hot and could cause burns.
Power adjustment can also be made during appliance operation:
- MANUAL mod. (Fig. 5), by means of the ignition and adjustment knob.
- REMOTE CONTROL mod. (Fig. 6), by means of the remote control and with the button loca-
ted on the control unit.
IMPORTANT! If the appliance is fuelled by LPG in the open air and with temperatures below
2°C the use of Propane gas is recommended.
14