Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.5 To install the nozzle:
The nozzles can easily be pushed over the hot
air nozzle. Never touch the nozzles during or
immediately after use of the device. The nozzles
are very hot.
8.6 Rotating handle:
The device has two handle positions (see Fig. C)
Position 1 is suitable for killing weeds and ignit-
ing the BBQ. In position 2, the device can be
used as a hot air gun.
To change the handle position (see Fig. C):
•
Press the release button (3).
•
Turn the handle (7) to the desired position.
•
Make sure that the release button (3) has
been locked again.
9 Option 1: Weed Killer
9.1 Assemble the extension handle:
The extension handle consists of two parts.
Connect both parts and attach the extension
handle to the device. To attach the extension,
place the extension handle in the machine and
turn the extension handle a quarter turn to the
right. Make sure that the extension handle firmly
clicks into position. If using the device as a
weed killer you must use the extension handle.
Hold the weed killer firmly by holding the end of
the extension handle.
7063006-Maxxheat-Basic-MA-1712-21.indb 11
9.2 Use:
•
Ensure the extension handle is firmly fixed
onto the device and that the device is
turned off.
•
Turn the device to position 1 (see Fig. C)
•
Install the nozzle (9) to destroy weeds.
•
Insert the plug into the socket.
•
Check to ensure the nozzle is not blocked
before turning the device on.
•
Set the temperature to setting II.
•
Allow the device about 45 seconds to
warm up.
•
To eliminate weeds, hold the nozzle over
the weeds for about 5 seconds. During
these 5 seconds the cell structure of the
weed is destroyed. As a result, the weed
dies within a few days.
•
It is not necessary to completely burn the
weeds, 5 seconds is more than sufficient.
•
For an efficient treatment the nozzle should
be held around 0 to 5 cm above the
weeds.
•
The effects are not visible immediately but
will take a while before they can be seen. It
is more of a long-term effect.
•
In the case of very leafy plants, the treat-
ment may have to be repeated several
times at intervals of 1 – 2 weeks.
1
10 Option 2: Specific weed killer
•
Ensure the extension handle is firmly fixed
onto the device and that the device is
2
turned off.
•
Turn the device to position 1 (see Fig. C)
•
Install the Heat-pin (11) to heat-treat the
weed.
•
Insert the plug into the socket.
•
Set the temperature switch in position "II".
•
Allow the device about 60 seconds to
warm up.
•
Position the heat-pin in the middle of the
weed, and push the pin into the weed, up
to the mark, and retract the heat-pin from
the soil after about 2 seconds.
•
The effect of the treatment will not be
immediately obvious as it can take several
.
11
04-01-18 11:05
Publicité
Table des Matières
