Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
Always check that the power supply
corresponds to the voltage on the
rating plate.
Class II machine – Double insulation
– You don't need any earthed plug.
4.5 Using extension cables
Only extension cables of type H05RN-F may be
used. Only use an approved extension cable
suitable for the power input of the machine. The
minimum conductor size is 1.0 mm
using a cable reel always unwind the reel com-
pletely Inadequate extension cords can be
dangerous.
If an extension cord is used, it shall be suitable
for outdoor use, and the connection has to be
kept dry and off the ground. It is recommended
that this is accomplished by means of a cord
reel which keeps the socket at least 60 mm
above the ground.
4.6 Connecting to power supply
This product is designed with a cord retainer
that prevents the extension cord from being
pulled loose while using.
NOTE: Always use cord retainer to properly
attach extension cord to the machine. Failure to
use cord retainer may result in damage to the
machine and/or extension cord.
•
Form a loop with the end of the extension
cord.
•
Insert loop portion of extension cord
through opening and place over cord
retainer.
•
Slowly pull loop against cord retainer until
the slack is removed.
•
Plug product into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from receptacle.
10
7063006-Maxxheat-Basic-MA-1712-21.indb 10
5 Technical Data
Voltage: . . . . . . . . . . 230 – 240 V~ 50 Hz
Power: . . . . . . . . . . . . . . . . 2000 W
Air flow: . . . . . . . . . . . . . . . 500 l/min
Setting I (venting / cooling): . . . . . . . .50 °C
Setting II: . . . . . . . . . . . . . . . . 600 °C
6 Unpacking
WARNING: Some packaging materials may be
hazardous to small children. Danger of suffoca-
. When
2
tion! Dispose of these materials responsibly!
Keep all the parts that are supplied with it in a
safe place.
Check that all parts are included and check for
possible faults.
Please contact the supplier or manufacturer if
parts are missing or are not in order.
7 Contents
1 Weed Killer
1 Nozzle for surface weed control (Fig. B, 9)
1 Heating pin for underground weed control
(Fig. B, 11)
1 Nozzle for BBQ / fireplace (Fig. B, 10)
1 Extension handle (2 parts) (Fig. A, 4)
1 Instruction manual
8 Operation
8.1 Before use
Do not touch the hot nozzle!
8.2 Temperature settings:
With the temperature switch (6) you can select
from two temperature settings. Depending on
the application, you can use the following
settings:
Setting I
Setting II
The volume of air in each setting 500L /Minute.
8.3 To turn on the power:
–
Push the switch (6) in position I or position
II.
8.4 To turn off the appliance:
–
Push the switch on position "0".
Always use with caution! Do not
cover the ventilation openings during
use as it causes a risk of burns!
50 °C (venting / cooling)
600 °C
04-01-18 11:05
Publicité
Table des Matières
