Charge Battery - Reflecta DigiMicroscope Professional Mode D'emploi

4.9 Charge Battery

Before using the microscope, you must charge its
battery.
1.
2.
3.
Plug the small end of the power adaptor into
the DC-in port located on the bottom side of
the unit. Then plug the other end of the power
adaptor into a standard AC outlet. The battery
indicator LED at the end corner of the unit will
be in red to show that the battery is charging.
When the battery is finished charging, the
battery indicator LED will be in off. Unplug the
unit.
You can now use your microscope for up to
two hours of continuous use. When the
battery is low, there will be low-power
indicator on the right down corner of the panel,
front LED light will become weak and image
quality becomes poor. Then you have to
connect the power adaptor and plug it in to
recharge the battery.
22