Opening Of The Balancer - Delachaux CONDUCTIX wampfler 040874-x2,0 Série Instructions D'utilisation

Operating Instructions
Balancer
040874-...x2,0
4

Opening of the balancer

Before each intervention, the spring/drum (27) must be released
For that, turn the screw (9) counterclockwise.
There are two possibilities to verify it:
1) About 4-6 mm protruding of the screw (9) (drawing H)
2) Little movement of the drum (27), when turning it with the wire by handcraft.
•
Install the balancer on an horizontal and stable surface.
•
Remove all 4 screws (1), lift the cap (11) and pull the wire (28) completely off.
•
The inner diameter of the spring must be stranded on the shaft (drawing L).
•
Verify the wire: if it shows wears according to type B or C, replace it immediately
(drawing I).
•
Verify the function of all gears during operation: frictionless axial running and twisting of the screw (9).
•
Make sure that the spring (12) squeezes the safety device (13) clamped with the screw (14) in Position H1 > 8 mm
(drawing G).
•
If squeezing the screw (9) down to the bottom, the screw end operates on the inclined surface of the device (13) and make it
fall in the position H2 < 2,5 mm (drawing G).
The screw (14) must hold back the safety device (13) in such a way it can freely move. So the pressure between H1 and H2
will be changed without any friction and resistance.
•
Make sure that the wire (28) is perfectly hold through the lock (25) and that the fastening screw (26) does not protrude
(drawing M).
BAL0400-0072a-D/E/F
www.conductix.com
Drawing L Drawing M
Seite 18 von 29