Putting Into Operation Of The Balancer - Delachaux CONDUCTIX wampfler 040874-x2,0 Série Instructions D'utilisation

Operating Instructions
Balancer
040874-...x2,0
1

Putting into operation of the balancer

Drawing A
This type of balancer can be used on an assembly line as well as on
individual working places.
Observation about the total load:
The tool, the accessories and the parts of the hoses and cables to be
supported have to be taken into consideration.
The total load must lie within the load capacity of the chosen
balancer.
For an optimal service, suspend the balancer hook (reference no. 33,
drawing A) on a working height within the middle of the pullout area of
the wire.
For the hanging up, use a solid stationary bracket or an horizontal
carriage.
If the load to be pulled has not been attached vertically under the
balancer, make sure it can freely move, in order to avoid important
wear.
Please note!
The "S" suspension of the balancer has always to be attached on a suitable bracket with the appropriated accessory
(NOT THE SAME ON WHICH THE HOOK (33) HAS BEEN SUSPENDED). Whereas an additional pullout of max. 100 mm has
to be taken into consideration (DIN 15112) (Drawing B).
Drawing B
Fastening of the accessory wire 20332:
Make sure the wire lays correctly; the clamp 20331 must lock both
parts of the superposed wire.
After the first screwing down, we recommend to fasten the clamp
with a 4Nm torque, in order to compensate the slackening,
between the wire and the clamp, generated during the first
clamping stage (Drawing B).
BAL0400-0072a-D/E/F
www.conductix.com Seite 13 von 29