Customer Service; Installation; Ventilation Requirements - AEG AHB41011AW Notice D'utilisation

Customer Service

If your appliance is still not working
properly after making the above checks,
contact the nearest service centre.
9.

INSTALLATION

WARNING!
Refer to Safety chapters.
Positioning
CAUTION!
If you are discarding an old appli-
ance that has a lock or catch on
the lid, you must ensure that it is
made unusable to prevent young
children being trapped inside.
This appliance should be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate class Ambient temperature
SN
N
ST
T
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where
to install the appliance, please turn
to the vendor, to our customer
service or to the nearest Service
Centre
AHB41011AW_AHB51021AW_AEG.indd 23
+10ºC to +32ºC
+16ºC to +32ºC
+16ºC to +38ºC
+16ºC to +43ºC
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your appli-
ance which can be found either on the
guarantee certificate or on the rating plate
located on the external right side of the
appliance.
The appliance shall have the plug
accessible after installation.
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your domestic
power supply.
• The appliance must be earthed. The
power supply cable plug is provided with
a contact for this purpose. If the domes-
tic power supply socket is not earthed,
connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
• The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
• This appliance complies with the E.E.C.
Directives.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
1. Put the freezer in horizontal position
on a firm surface. The cabinet must be
on all four feet.
2. Make sure that the clearance between
the appliance and rear wall is 5 cm.
3. Make sure that the clearance between
the appliance and the sides is 5 cm.
ENGLISH 23
2017-06-08 14:21:32