Service And Maintenance; Running In Period; Machine Cleaning; Changing Blades - PACLITE Equipment MASTER 600 Manuel De L'opérateur

Masquer les pouces Voir aussi pour MASTER 600:

Table des Matières

Les langues disponibles

MASTER 600-700-900-1200

MAINTENANCE

The Paclite MASTER Trowel is designed to give many years of trouble free operation. It is, however, important

that the simple regular maintenance listed in this section is carried out. It is recommended that an approved

Paclite Equipment dealer carry out all major maintenance and repairs. Always use genuine Paclite replacement

parts, the use of spurious parts may void your warranty. Before any maintenance is carried out on the machine,

switch off the engine and disconnect the HT lead from the spark plug. Always set the machine on level ground

to ensure any fluid levels will be correctly read. Only use recommended oils.

RUNNING IN PERIOD

When the trowel is first used from new, the engine oil must be changed after the initial running in period. (see

engine manual for full details).

MACHINE CLEANING

Clean the machine after it has been used to prevent the collection of hardened cement. The blades can usually

be cleaned with a high-pressure hose and water while the concrete is still wet. Hard cement/concrete is very

difficult to remove. Immediately replace any labels/stickers should you notice that they are worn, missing, or

damaged.

CHANGING BLADES

Be careful when changing old blades for new. Due to the way the blades wear, the old blades

become very sharp and can cut easily. Wear heavy duty gloves to avoid injury.

BLADES MUST BE REPLACED AS A SET!!!

CAUTION

Rountine maintenance

Check condition

Air Filter

Clean/Replace

Engine Oil

Cutout Switch

Belt Tension

Spark Plug