Installation And Use - Skytec 160.428 Manuel D'utilisation

Safety
Plug the smoke machine only in an earthed mains outlet or extension
cord! ATTENTION: the powercord can only be replaced by an original
replacement, supplied by SkyTronic.
Be careful when filling the fluid tank. First of all, unplug the mains
lead! Then unscrew the cap on the tank and fill it by means of a
funnel.
Only use the original SkyTec smoke fluid which is environmental
friendly and, if used correctly, leaves no residues (see page 3).
Do not obstruct the openings on top of the case to guarantee a good
ventilation. The heating element of the smoke machine generates
heat which needs to be removed. Don't put any objects on the smoke
machine.

Installation and Use

Unpack the fog machine. Do not connect yet the net cable. Connect
the lead of the manual control with the 3-pin plug at the rear of the
smoke machine. Fill the fluid tank by means of a funnel. Plug the unit
into a mains outlet. Thus the heating element is automatically
switched on. Depending on the room temperature, it takes about 9 to
10 minutes until the working temperature is reached. Then the
thermostat is clicking and the red LED on the manual control lights
up.
Push the red switch once and the smoke machine will produce a nice
thick fog. Once the smoke machine has reached its working
temperature (the red LED is lit) the smoke machine can produce
continuously fog during about 2 minutes.
After this period of time, the fog generator is cooled so much down
that the thermostat switches off. Wait a few minutes until the working
temperature is reached again. It is recommended to produce smoke
with small pauses in between so that the temperature is maintained
and the thermostat doesn't switch off.
Location
Select a location where it is easy to fill the tank. It is also possible to
hang the unit by means of the supplied holder and fixing screws.
- 3 -