Domo DO7074S Mode D'emploi page 32

DO7074S WWW.DOMO-ELEKTRO.BE
Note:When changing your temperature control dial setting from high setting to lower,
it is proposed that not to start ironing immediately since there may be any burns
caused on your fabrics by high temperature. Please wait for temperature indicator light
(in iron unit) stop blinking, and then start ironing.
Otherwise burns will be caused to your fabrics.
VERTICAL STEAM IRONING
Follow the steam ironing process, and then hold the iron in vertical position between
5cm and 15cm away from the hanged fabrics. Press down steam switch, this will cre-
ate vertical steam. This feature is especially used for removing creases from hanging
clothes and curtains. Never directly perform steam ironing on people.
NOTE:
a. During the steam process, the surface temperature of the supply hose would be quite
hot. It is normal since there has steam passing through the steam transportation pipe
inside from the base to iron. Do not touch by hand!
b. Please keep the supply-hose unblocked and untwisted.
REPLACEMENT OF FILTER
How often the filter needs to be replaced depends on the water hardness. We recom-
mend to change the filter every 4 – 6 months.
Follow below procedure to replace the filter:
I. Slide out the water tank from the base, and then take out the filter from the water
tank.
II. Replace it with a new one.
III. Re-install it into the water tank.
IV. Fill water into water tank up to MAX fill level, and slide water tank into the power
base again.
Note: For every first use of the filter, please put the filter for 10 min. it in water for bet-
ter performance.
SAFETY PROTECTION DEVICE
This appliance has a safety valve protection device on the base unit. If the supply hose
is blocked accidentally, the safety valve will be opened to release the steam under the
base unit. This is normal that it may produce a high pitch sound. Once this abnormal
condition happened, unplug the appliance
immediately. To check whether any damage is found in the supply hose.
ANTI-SCALE SYSTEM
1. Filter is designed to reduce the build-up of limescale which occurs during steam
ironing, this will prolong the working life of your iron. However, please note that the
filter will not completely stop the natural process of limescale build-up.
2. Filter should be replaced with a new one after about 4-6months use. Working life of
32