Important Safeguards - Domo DO7074S Mode D'emploi

DO7074S WWW.DOMO-ELEKTRO.BE

IMPORTANT SAFEGUARDS

Make sure to read all the safety precautions below and look at the illustrations before
you start using the appliance.
1. Read all instructions carefully before using.
2. Use the appliance for its intended use only.
3. The appliance is intended for household use only.
4. To protect against the risk of electric shock, do not immerse the iron and main base
into water or any other liquids.
5. Connect the appliance only to an alternating current of the voltage specified on the
rating plate and only to an earthed main socket.
6. The appliance should always be turned to OFF before plugging or unplugging from
outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to dis-
connect.
7. Do not allow power cord or supply hose to touch hot surface.
8. Always disconnect the plug of the appliance from the main socket when filling with
water or emptying and when not in use.
9. Do not operate the appliance with a damaged cord or if the appliance has been
dropped or damaged. To avoid a hazard such as the risk of electric shock, do not disas-
semble the appliance, it must be taken to a qualified serviceman or manufacturer or its
service agent for examination and repair.
Incorrect re-assembly can cause a risk of electric shock when the iron is used.
10. Place the iron out of the reach of children, close supervision is necessary for any
appliance being used by or near children. Do not leave the iron unattended while con-
nected to the supply mains.
11. Always place the iron on the iron rest plate horizontally. Do not put the hot iron
onto the power cord or the supply hose.
12. Use and place the appliance on a stable, level and horizontal surface or ironing
board.
13. Burns can occur from touching hot metal parts, hot water or steam. Use caution
when using the appliance. If the iron is placed onto the iron rest plate during in use,
the iron rest plate may become a hot surface. Do not touch the iron rest plate and the
sole-plate until they have cooled down
completely.
14. Never use the iron facing towards the people because the steam can cause burns.
15. Never wind the supply hose during use.
16. To avoid a circuit overload, do not operate another high wattage appliance in the
same circuit
17. If an extension cord is absolutely necessary, a 15-ampere cord should be used.
Cords rated for a lower amperage may overheat, care should be taken to ensure that
the cord cannot be accidentally pulled or tripped over.
18. The iron must not left unattended while it is connected to the supply mains.
19. When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
28