Important Hints; Steam Ironing - Domo DO7074S Mode D'emploi

DO7074S WWW.DOMO-ELEKTRO.BE
er temperature (such as nylon etc.) immediately. It is advisable to adjust the tempera-
ture button to the lower setting, waiting for about 2-6 minutes till the power indicator
light turn off, and then you can start ironing.

IMPORTANT HINTS

Do not fill water tank with vinegar, perfume starch, chemically descaled water or des-
caling agents.
PREPARE THE APPLIANCE FOR USE
1. Check if the voltage indicated in the rating plate corresponding to the main voltage
in your home.
2. Remove the protective foil or sticker or card from the soleplate.
3. Fully unwind and straighten the power cord and the supply hose.
4. Place the appliance on a stable, level and horizontal surface such as ironing board.
5. Place the iron onto the iron rest plate horizontally at the base unit.
FILL WATER TANK
1. Press upwards the release button at the water tank and slide the detachable water
tank outwards from the base.
2. Fill the water tank up to or below the "MAX" fill line with the clean tap water. (You
can take filter out of the opening for filling water into water tank, or fill water into
water tank directly with the filter existing in the opening.
3. Replace the water tank into the base unit again. It will be locked in place with the
base unit until a "click" sound is provided.
4. Always pour out the remaining water after use.
Note: When the water level reaches a low level or the water tank is empty, pump will
provide sound to indicate refilling. Stop to use the appliance immediately and refill
water tank.
STEAM FUNCTION SETTING
After power on, if steam is necessary, set temperature control dial to steam ironing
position according to fabric. When temperature set at "MAX"steam adjustable knob
should be set at "MIN" range, if temperature control dial set at "COTTON/LINEN"
position, steam adjustable knob should be set at MIN position, If water leakage hap-
pens during use, set temperature control dial at higher temperature position or steam
adjustable knob to lower position.
When temperature control dial set at "WOOL/SILK" or "SYNTHETIC", do not use
steam ironing, otherwise, water leakage will happen from soleplate. Steam ironing
cannot be activated until heating indicator light turn off.

STEAM IRONING

1. Fill the water tank with clean tap water refer to above filling instructions.
(Note: For every first use of the filter, please put it in water for 10 min for better
30