Using Only The Front Speakers (2 Channel Stereo); Adjusting The Level Parameters - Sony AVD-S50ES Mode D'emploi

Using only the front
speakers
(2 Channel Stereo)
Press 2CH ST on the receiver or
SOUND FIELD on the remote repeatedly
until "2CH STEREO" appears on the
front panel display.
This mode outputs the sound from the front
left and right speakers only. Standard 2
channel (stereo) sources completely bypass
the sound field processing. Multi channel
surround formats are downmixed to 2
channel.
Notes
• To listen to 2 channel (stereo) sources using the
front left and right speakers and a sub woofer, press
AUTO DEC on the receiver or SOUND FIELD on
the remote repeatedly to select "AUTO DECO."
• Depending on the speaker setting, the sound is
output from the sub woofer.
Adjusting the level
parameters
The level menu contains parameters that let
you adjust the balance and speaker volumes
SOUND
of each speaker (page 27).
FIELD
1
2
3
4
ENTER
C/X/x/c
Start playing a program source
encoded with multichannel
surround sound.
Press AMP MENU repeatedly.
9 LEVEL appears on the front panel
display.
Sit in your listening position and
select the item to be adjusted
using X/x.
Adjust the volume level using C/c.
The adjusted value will appear on the
front panel display. If you do not operate
the remote for a few seconds, the value
turns off and is stored in the receiver.
AMP MENU
US
51