Sportplus SP TM 4220E Mode D'emploi page 64

8. USING THE COMPUTER
TROUBLESHOOTING - PROBLEMS WITH THE COMPUTER DISPLAY
Error
Cause
message
Nothing
shown
on all
Error on
screens
transformer.
after
switch-
ing on.
No error
code, no
function
Error on control
of the board.
walking
belt.
NOTES
• If the computer display does not show any values, thoroughly check all plug
connections for proper contact.
• The calorie consumption values (metabolic rate) the computer calculates and
displays are intended as a rough guide, and offer the user (of medium height on
medium resistance setting) the opportunity to compare training sessions. The values
may vary from the actual, medically accurate metabolic rate.
• The computer is not calibrated, and the heart rate values it calculates and displays
are intended as a rough guide and may vary greatly from the actual heart rate.
• This computer was tested according to applicable EMC standards. Nevertheless, the
display may malfunction, especially due to electrostatic discharge. This may result
in unwanted reset or incorrect display of values. Should this happen, you need only
restart the computer (turn it off and back on).
SP-TM-4220E-IM-05-DE+GB+FR.indb 64
Solution
Check if the overload
protector is in ON
position or not.
Check if the connecting
wires among power
switch, overload
protector and the motor
control board are well
connected or not.
Check if cables
connected to the motor
are well fixed or not.
64
Further action
Reset the overload
protector to ON position.
Replace the transformer.
Replace the motor
control board.
15/6/2016 18:46