Skil BL4713-00 Guide D'utilisation page 13

To Attach/Detach Battery Pack
WARNING
Therefore, remove the battery when assem-
bling parts, making adjustments, cleaning,
when the tool is not in use, or when carry-
ing it at your side . Removing the battery
pack will prevent accidental starting that
could cause serious personal injury.
To attach the battery pack (Fig . 4):
Align the ribs of the battery pack with the
•
mounting slots in the blower's battery port.
Press the battery pack toward the blower
•
body until it snaps into position.
NOTICE: Make sure that the latch on the
blower snaps into place and the battery pack is
secured to the tool before beginning operation.
To detach the battery pack:
WARNING
children, or pets when pressing the bat-
tery-release button. Serious injury could
result if the battery pack falls .
NEVER remove the battery pack at a high
location .
Press the battery-release button to cause
•
the battery pack to disengage from the latch
and the ejection mechanism will assist with
removal.
Grasp the battery pack and remove it from
•
the blower.
To Start/Stop the Blower
Your blower can be started or stopped in two
ways, as well as air speed adjustment.
With the Variable-Speed Trigger Switch
(Fig . 6):
Depress the variable-speed trigger switch to
•
turn on the blower.
The air speed of the blower is controlled
•
with the variable-speed trigger switch. More
pressure on the trigger results in higher
blowing speeds; less pressure on the trigger
results in lower blowing speeds. Adjust the
speed to suit the task at hand.
Release the variable-speed trigger switch to
•
turn off the blower.
Battery tools are always
in operating condition .
Always be aware for the
location of your feet,
Fig. 4
Fig. 5
Fig. 6
Press to release
Variable-Speed
Trigger Switch
13