Cleaning & Maintenance - Princess 01.359000.01.001 Mode D'emploi

Instruction manual
• Twist both ends of the exhaust hose into the square fixing clip and the
flat fixing clip.
• Insert the square fixing clip into openings at back of the air conditioner.
• Put the other end of the exhaust hose to the near windowsill.
Window Slider Kit Installation
• The installation manner of window slider kit is mostly in "horizontal"
and "vertical", No much difference in actual process.
6
CLEANING MAINTENANCE
• Before cleaning, be sure to disconnect the unit from any electric supply
outlet.
• First clean the surface with a neutral detergent and wet cloth, and then
wipe it with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Do not wash the unit directly.
• If the conditioner is damaged, please contact the dealer or repair shop.
Air Filter
• If the air filter becomes clogged with dust/dirt, the air filter should be
cleaned once every two weeks.
• Open the air inlet grille and take off air filter.
• Clean the air filter with neural detergent in lukewarm（40°C（and dry it
up in the shade.
• Putting the air filter into the inlet grille, replace the components as
they were.
TROUBLE SHOOTING
Troubles Possible Causes
The unit does not start • Water full indicator lamp blinks,
when pressing power and water tank is full.
button • Room temperature is higher
than the setting temperature.
(Electric heating mode)
• Room temperature is lower
than the setting temperature.
(Cooling mode)
The unit doesn't cool • The doors or windows are
enough not closed.
• There are heat sources inside
the room.
• Exhaust air hose is not
connected or blocked.
• Temperature setting is too high.
• Air inlet is blocked.
Suggested Remedies
• Dump the water out of the
water tank.
• Reset the temperature
• Reset the temperature
• Make sure all the windows
and doors are closed.
• Remove the heat sources if
possible
• Connect or clean the exhaust
air hose.
• Reset the temperature
• Clean the air inlet.