Maintenance - EdilKamin MITO IDRO Installation, Usage Et Maintenance

MAINTENANCE

Before performing any maintenance, disconnect the applian-
ce from the mains.
1
Regular maintenance is required for the boiler-stove to fun-
3
ction correctly.
Any problems resulting from lack of maintenance will imme-
diately void the warranty.
N.B.
- Any unauthorised modi cation is forbidden
2
- Use spare parts recommended by the manufacturer
- The use of counterfeit parts results in the guarantee beco-
ming null and void
DAILY MAINTENANCE
Operations must be performed when the boiler-stove is off,
cold and unplugged from the power supply.
Cleaning should be carried out with the aid of a vacuum clea-
ner (see optional page. 58), the whole procedure takes up a few
minutes.
fi g. A
• Open the door, remove the combustion chamber (1 - fi g. A) and
empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided,
removing any obstructions in the openings.
• DO NOT EMPTY THE RESIDUE OUT INTO THE PEL-
LET HOPPER.
• Take out and empty the ash (2 - fi g A) pan into a fi reproof con-
tainer (the ash may still contain hot parts and/or embers).
• Vacuum clean the inside of the fi replace, the fi re surface, the
*
compartment around the chamber where ash falls, and the ash
pan.
• Vacuum the combustion chamber holder, clean the edges where
the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
AT LEAST ONCE A DAY ACTION THE CLEANING
BRUSHES OF THE EXCHANGERS (*), EVEN WHILE
THE STOVE IS LIT, USING THE GLOVE PROVIDED:
- Proceed shaking the cleaning handle under the ceramic top (*
- fi g. B).
fi g. B
NEVER SUCTION HOT ASH, as this could damage the
suction device and possibly cause a re.
ATTENTION:
MAKE SURE THE ASH PAN IS CORRECTLY POSITIO-
NED IN ITS HOUSING (2 g. A)
WEEKLY MAINTENANCE
• Clean the hearth (with the tube brush).
• Vacuum the pipe near the electric coil (3 - fi g A).
- 53
-