LENCO PIR-645 Mode D'emploi page 9

Push You must start the WPS scan on the remote station (e.g. router). Consult the
Button manual for your router or Access Points (AP) to learn how to do this. After you
have done this, press "-Vol+/OK/Tune" knob on the radio and then both
devices will establish a connection.
Pin The radio creates an 8-digit number, which you then have to enter into the
remote station. After entering the PIN, press the "-Vol+/OK/Tune" knob to
establish the connection between both devices.
Skip In addition to a WPS connection, you can also establish a connection using a
WPS Pre-Shared-Key. The required key is often on the rear of the router, or you may
have defined it yourself. This method is used automatically for networks
without WPS. You can call up the Pre-Shared-Key function on networks with
WPS by selecting menu item "Skip WPS".
An input field should now appear. You can enter the required key (PSK) by
turning and pressing "-Vol+/OK/Tune" knob, and then select"OK" and press
"-Vol+/OK/Tune" knob to complete the entry. The radio should now establish
the connection to the network.
5) Setup wizard completed, press "-Vol+/OK/Tune" knob again to exit.
Internet Radio Mode
To select internet radio station, follow below section to choice stations.
1. Press Mode button to choose Internet Radio
2. For Initial use, it will display the options for you to find internet station.
You can find different internet radio station in next menu by different method.
Local Local location will change according to your current
location location (e.g. Germany). It displays local stations of your
9