Parkside PAH 1700 C4 Instructions D'utilisation Et Consignes De Sécurité page 31

Troubleshooting
Problem Possible
cause
Chisel holder
Chisel 12 13
11 does not
falls out.
lock.
Product does No mains
not work. power.
Worn-out
carbon
brushes 16.
Motor
defective.
Poor
Blunt chisel 12
performance.
13.
Excessive
pressure on
the product.
Stroke rate set
too low.
Grease used
up.
30 GB/IE
The packaging is made entirely of recyclable
Solution
materials, which you may dispose of at local
recycling facilities.
Reinsert the
chisel 12 13
into the chisel
holder 11 (see
"Inserting/
removing the
chisel").
Check power
cord and
power plug
5 . Have
the product
repaired by
a qualified
specialist.
Have the
carbon brushes
16 replaced
by a qualified
specialist.
Have the
product
repaired by
a qualified
specialist.
Use new chisel
12 13.
Apply
appropriate
pressure.
Increase stroke
rate (see
"Selecting the
stroke rate").
Add grease 14
(see "Main-
tenance").
Disposal
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and
fibreboard / 80–98: composite
materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment.
The Triman logo is valid in France only.
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when
it has reached the end of its useful
life and not in the household waste.
Information on collection points and
their opening hours can be obtained
from your local authority.