Product Description - GYS SPOT LIFT PRO Mode D'emploi

MADE IN FRANCE
EN

Product description

Serial number
Verification phase
Technical table on the jack
Load capacity in the table
Network pressure in the panel and on the control unit
Instructions for use (original)
Signalling up / down of the jack on the control unit
Tight fastening of all bearing screws
Tightening of nuts on all axes
Condition of pneumatic lines and ductwork
Safety valve set at 5.5 bar
Mains pressure gauge Pmax < 5.5 bar
The control lever automatically returns to the central position
when released.
Condition of removable arms, skids and pins
Condition of the central beam and axis fixing
Bellows condition
Condition of the supporting structure (scissors and trays)
Functional test of the lifting platform with vehicle
Control result
Security check carried out on : ............................................................................................................................
Name and address of the authorised person : ..........................................................................................................
SPOT LIFT PRO
Commissioning is not allowed
No anomalies: commissioning granted
SPOT LIFT PRO
OK NOK Verification
Signature of the authorised person
EN
Note
49