Safety Precautions - AudioSonic RD-8520 Mode D'emploi

SAFETY PRECAUTIONS

• Do not drop the device and do not expose it to liquid, moisture or
humidity. These might lead to damage to the device.
• If the device is moved from a cold environment into a warmer
one, let it adapt to the new temperature before turning it on.
Otherwise, it might lead to condensation and cause malfunctions
in the device.
• Do not use the device in a dusty environment as dust can
damage the interior electronic components and lead to
malfunctions in the device.
• Protect the device from strong vibrations and place it on stable
surfaces. Do not attempt to disassemble the device.
• Only use the power adaptor delivered with the device. The socket
outlet should be installed near the device and should be easily
accessible. Never touch the power plug with wet hands and
never pull on the power cable when pulling the plug out of the
power socket.
• Make sure the electrical voltage specified on the device and its
power plug is corresponding to the voltage of the power socket.
Incorrect voltage will destroy the device. The normal functioning
may be disturbed by strong electro-magnetic interference. If
so, simply reset the product to resume normal operation by
following the instruction manual. If the radio could not resume,
please use it in other location.
• If the device is not used for a long period of time, disconnect it
from the power supply by unplugging the power plug. This to
avoid the risk of fire. It is not recommended to listen to the device
with a headphone via LINE OUT. In case you use a headphone,
always reduce the volume before put on the headphones. After
the headphones are positioned properly, increase the volume to
the desired level. It is not recommended to use headphone with
the device through the 3.5mm audio out socket. In case of using
the headphones, be reminded that excessive sound pressure or
volumes from headphones or earphones can lead to damage to
your hearing. Always adjust the volume to a pleasant, not too
loud level. If you have adjusted the volume of the headphone to
be too loud and that for an extended period, it can damage your
hearing.
• Always power off the device when you are cleaning it. Never use
any harsh or strong solvents to clean the device since these may
damage the surface of the device. Dry, soft cloth is appropriate,
however, if the device is extremely dirty it may be wiped off
with a slightly moist cloth. Make sure the device is dried off after
cleaning if you have to dispose the device in the future, note
that it should not be disposed with household waste. Bring it to
a collection point for the recycling of electrical devices. Consult
your local authority or retailer for recycling advice.
EN
Instruction Manual
3