Charging/Operating A Usb Device (See Fig. C); Use Belt Clip - Parkside PAA 20-Li B2 Traduction Des Instructions D'origine

Charging/operating a USB device (see fig. C)
NOTE
► If only a small current (<130mA) is drawn, the battery adapter
switches off after a short time.
It is therefore not possible to charge or operate such a device.
♦ Connect your USB device to the USB port
adapter .
♦ Press the ON/OFF switch
The control LED
trol LED lights up permanently to indicate the power supply.
Your device can now be charged or operated on the battery
adapter .
♦ To turn off the USB port
for around two seconds.
The control LED
♦ If you are no longer using or charging your device, disconnect it
from the battery adapter

Use belt clip

■ With the belt clip
attach to a belt or the like.
│ GB │ IE
■ 20
to activate the battery adapter
flashes four times and then lights up. The con-
, press the ON/OFF switch
goes out after a short time.
.
you can use the battery adapter
of the battery
again
z. B.
PAA 20-Li B2
.