Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
61401274_GB_DE_Maquetación 1 30.05.2012 14:31 Page 18
GB
fig. 4
TURNING THE APPLIANCE ON
The first time the cooktop is plugged in (or
after a power outage), the Block function
will appear as activated (pilot light 10 on).
In this case, you must deactivate the block
function in order to turn the cooktop on. To
do this, push sensor
turns off.
1 Touch sensor
second.
Touch Control is now activated and a
appears in all power indicators (3). If a
cooking zone is hot, the corresponding
indicator will show an
vely.
Once the Control is on, you must activate
a plate within 10 seconds, otherwise the
Touch Control will automatically turn off.
While the touch control is activated, it can
be disconnected at any moment by tou-
ching the general on/off sensor
even if it has been blocked (see section
"Blocking cooktop sensors"). Sensor
(1) always has priority in disconnecting the
touch control.
18
ACTIVATING PLATES
Once the Touch Control is activated with
sensor
by following these steps:
1 Select the plate by using the correspon-
(6) until pilot (10)
(1) for at least one
0
2 Use the cursor slider (2) to choose a
H
0
and a
alternati-
As long as the plate is selected, in other
words, with the decimal point lit up, its
power level can be modified.
TURNING A PLATE OFF
A plate can be turned off by decreasing its
(1)
cooking level to
plate must have been previously selected
(decimal point lit up).
Once a plate has been turned off, an
appear on the corresponding power indi-
(1), any plate can be turned on
ding sensor (3). In other words, press
with your finger the NUMBER INDICA-
TOR. If the glass is hot, the said indica-
tor will go from showing an H to showing
level 0. The decimal point to the bottom
right of the number lights up, indicating
that the plate has been selected.
0
cooking level between
0
. In order to do this, the
9
and
.
H
will
Publicité
Table des Matières
