Preparation; Application; General - Sanitas SMA 35 Mode D'emploi

2. Preparation

This manicure and pedicure instrument is equipped with high-quality at-
tachments. The basic version includes 7 attachments with long-life sapphire
coating or polishing felt.
Together with the 2-level speed control and clockwise/anticlockwise ope-
ration, this ensures a professional pedicure and manicure that would other-
wise only be possible at a podiatrist.

3. Application

3.1 General

– This instrument is intended only for the treatment of hands (manicure)
and feet (pedicure).
– Make sure that the device is switched off beforehand.
– Select an attachment and push it onto the instrument spindle using a
slight pressure. To remove: pull the attachment and instrument apart in
the axial direction (straight).
– Switch the device on by moving the slide switch down (anticlockwise,
LED red) or up (clockwise, LED green).
– All file and cutting attachments are coated with a sapphire grain.
This guarantees extremely long life and almost guarantees freedom from
wear.
– You can select one of two speed settings (Hi and Lo). Press the corre-
sponding button on the device
– Do not exert heavy pressure and always guide the attachments carefully
over the surface to be treated.
– Move the instrument under light pressure in circular movements slowly
over the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is sof-
tened or moist. For this reason, do not carry out any pretreatment in a bath.
– Do not remove all the callus skin in order to retain the natural protection
of the skin.
– Always ensure that the spindle can rotate freely. It must never be perma-
nently jammed, otherwise the instrument will become too hot and suffer
damage.
– After every use, apply moisturizing cream to the parts treated.
13