Solo Cleanline 305A Instructions D'emploi page 15

4 Using the pressure sprayer
Ensure that you follow all of the safety
instructions when using the pressure
sprayer.
Every time you use the pressure sprayer, first
check it all over to ensure it is safe to use
according to section 2.2.
The pressure sprayer can also be carried by the
pump handle (3), if the pump handle is pressed
down completely, and it is turned to the right and
clicked into position.
4.1 Spraying
To pump, loosen the pump handle (3) by turning
out of the stop position. Pump the unit until the
operating pressure is reached in the spraying
agent tank. Excessive pressure escapes
automatically through the pressure relief valve (4).
Hold the spray tube at the shut-off valve in your
hand.
Start the spraying process by pressing the shut-off
valve (5) (a).
Releasing the shut-off valve stops the spray
process.
The blue clip can be used to secure the shut-off
valve in its rest position to prevent accidental
spraying. For this, pull the lever slightly away (a)
from the handle and lock the clip (b).
4.2 Residual spraying agents /
finishing spraying
Switch off the pump immediately when any air is
sucked in and sprayed out through the spray
nozzle. This is indicated by a mist being sprayed
from the nozzle. At this point the spraying agent
tank will still contain a residual amount of less than
10 ml [6.8 oz]. If you do not want to fill in any more
spraying agent and want to end spraying, collect
and dispose of the remaining amount according to
the applicable laws and provisions. Observe the
information from the spraying agent manufacturer.
When you finish working, prepare the device for
storage according to section 5.3, thoroughly wash
your face and hands with soap, take off your work
clothing and ensure that it is washed regularly.
ENGLISH 8