Kenwood KDC-BT710DAB Mode D'emploi page 20

BLUETOOTH®
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons
(1 to 6).
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [CALL HISTORY],
[PHONE BOOK], or [NUMBER DIAL], then press the knob.
3 Turn the volume knob to select a contact or enter a
phone number.
If a contact is selected, press the volume knob to show
the phone number.
4 Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select
2
[NUMBER DIAL] in step and store a blank number.
Make a call from memory
1 Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
16
ENGLISH
Other settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table), then press the
knob.
3 Repeat step 2 until the desired item is selected/activated or follow the instructions
stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
BT MODE
PHONE SELECT Selects the phone or audio device to connect or disconnect.
"*" appears in front of the device name when connected.
" " appears in front of the current playback audio device.
AUDIO SELECT
• You can only connect a maximum of two Bluetooth phones and one Bluetooth audio device
at any time.
1 Turn the volume knob to select a device to delete, then press the knob.
DEVICE DELETE
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
1
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected Bluetooth device is within
range. ; OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/iPod touch/Android
device) when it is connected through USB input terminal. Depending on the operating system
of the connected device, this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing, phonebook, and etc.). ;
NO: Cancels.
.
2
and until you finish entering the PIN code.
Default: XX