Control Horn And Servo Arm Settings; Pnp Receiver Selection And Installation - Horizon Hobby FORCE RC Bare Bear Manuel D'utilisation

EN

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the gain
values may need to be adjusted. Refer to your receiver manual for adjustment
of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.

PNP Receiver Selection and Installation

The Spektrum AR636 receiver is recommended for ths airplane. If you choose
to install another receiver, ensure that it is at least a 4-channel full range
(sport) receiver. Refer to your receiver manual for correct installation and
operation instructions.
Installation (AR636 shown)
1. Remove the canopy from the fuselage.
2. Mount the receiver parallel to the length of the fuselage as shown. Use
double-sided servo tape.
CAUTION: Incorrect installation of the receiver could cause a crash.
3. Attach the appropriate control surfaces to the their respective ports on the
receiver using the chart in the illustration.
6
Horns
Elevator
Rudder
Ailerons
More control throw
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
Bare Bear
Arms
Less control throw