Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remote control buttons
•
Cool mode: In cooling mode, the LED lamp is blue. Press this
button to activate the cooling mode. Note: The default start mode
is the cooling mode.
•
Heat mode: The display number in heat mode is orange. Press
this button to activate the heat mode.
•
Oscillation button: Press the Oscillation button to turn on the
oscillation function. The fan will swing from left to right. Press this
button again to stop oscillating.
•
Power button: The device can be switched on and off by pressing
the power button.
•
Increase/Decrease volume of air: Press the "+" button on the left
side of the remote control to increase the volume of air, press the
"-" button on the left side of the remote control to decrease the
airflow. It can be set in 1-10 fan speed in cooling mode, heat
mode can be set for 4 levels.
•
Natural mode: The device show the current fan speed on screen,
the fan simulates the natural breeze, it works in both cooling and
heating mode.
•
Timer: Press the timer button to select the desired range between
1 hour to 24 hours.
•
Sleep mode: Sleep mode works in both heating and cooling. The
fan speed will reduce to speed 1 from whichever fan speed you
set. The display will show the current fan speed where it reduced
to.
•
Increase/Decrease temperature: In heat mode, press the
temperature button on the right side of the remote control to set
the temperature between 16°C and 30°C. Note: this button does
not work in cool mode.
•
Mute: This will turn off the sounds of the device.
Heating mode instructions
•
Press the heat mode button and the display shows the ambient
temperature.
•
Press temperature button to set the temperature, the display will
flash digitally, which can be set to 16 to 30 degrees.
•
Set temperature should be higher than the ambient temperature,
so that the heating function will be turned on.
•
When the ambient temperature reaches the target temperature,
the heating element will stop for a while and machine will be
fanning to vent heat, after a few seconds the fan will stop too until
the ambient temperature is below target temperature.
•
If the ambient temperature is lower than the set temperature the
heating function will activate automatically.
•
Note: The default setting temperature is 20 °C. In the heat mode,
when the ambient temperature is below 0 °C, the display only
shows 01, it does not display negative temperature value. When
the heat mode runs over 9 hours, the machine will automatically
stop. Restart by pressing the host power button or by using the
button on the remote control.
Instruction manual
EN
7
Publicité
Table des Matières
