Declaration Of Conformity - Bosch Cutter Notice Originale

OBJ_BUCH-2057-004.book Page 18 Wednesday, March 2, 2016 3:35 PM
18 | English
Technical Data
Cutting adapter
Article number
Weight according to EPTA-
Procedure 01:2014

Declaration of Conformity

We declare under our sole responsibility that the product described un-
der "Technical Data" complies with all applicable provisions of the direc-
tive 2006/42/EC including its amendments.
Technical file (2006/42/EC) at:
Robert Bosch Power Tools GmbH, PT/ETM9,
70538 Stuttgart, GERMANY
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch Power Tools GmbH
70538 Stuttgart, GERMANY
Stuttgart, 01.01.2017
Assembly
 Before any work on the screwdriver with cutting adapter (e.g.
maintenance, tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the middle position.
There is danger of injury when unintentionally actuating the On/Off
switch.
Attaching the Cutting Adapter (see figures A1 – A2)
– You have to pull the rubber cap 9 of the screwdriver off toward the
front before mounting the cutting adapter 1.
– Then attach the cutting adapter to the screwdriver.
The cutting adapter must audibly engage.
Note: You can attach the cutting adapter in 8 different positions. This en-
ables you to achieve the optimum work position, e.g. for cutting a floor
covering along a wall.
1 609 92A 1NB | (2.3.16)
Cutter
1 600 A00 1YN
kg 0.15
Bosch Power Tools